Charging: On the back of the mirror where the power button is located, carefully lift the silicone cover and find the USB-C port. Plug the included USB-C charging cable into the USB-C port and the other end into a USB-friendly power source. Once the cable is connected, the wave symbol will light up green. When the mirror is charged, the green light will turn off. Please then carefully replace the silicone cover and make sure it is tightly sealed. | Installation: Choose a flat, joint-free and completely smooth surface (e.g. glass or glossy tiles). Do not install on rough, uneven or textured surfaces or over joints. Clean, rinse and dry the surface with a lint-free cloth. Make sure the surface is completely dry. Rinse the suction cup and wipe off any excess water. Press the suction cup firmly against the chosen surface with both hands and turn the "suction cup mount" 45° clockwise with both hands and considerable force until it clicks into place. A firm twist is required. Check that the suction cup is secure. Please note that unlike "classic" suction cups, this suction cup is not securely attached until it is rotated to the locked position. If you attach the suction cup without locking, the mirror will fall off. Hold the mirror firmly by the sides with both hands and press it firmly onto the suction cup ball until it clicks into place. Be prepared to press firmly. Do not press on the glass. Hang the wiper lip on the neck of the wall mount. To remove the wall mount from the surface, turn it to the left until it is completely released. You may need to pull on the small tab to release the wall mount from the surface. How to use: Reach behind the mirror with your left hand and long press the power button. This will activate the anti-fog technology, which is indicated by the red wave symbol and the LED lights on. Please do not touch the mirror surface when it is on. Once you are finished using the mirror, reach behind the mirror with your left hand and long press the power button to turn off the anti-fog technology and the LED lights. After 7 minutes of use, the mirror will automatically turn off to minimize battery consumption. If there are drops on the mirror, use the wiper lip to clean it. Allow the mirror to cool down for 10 minutes after every second use. Charging:
When the mirror needs charging, the red light will flash. Simply tilt the mirror down toward you at a 90° angle away from the wall mount. The mirror will then release itself. You do not need to remove the wall mount from the wall to remove the mirror. Follow the charging instructions above to recharge your mirror.
