HYDRO EXFOLIATOR

How to charge your Hydro Exfoliator: Plug the included USB charging cable into the USB port on the device. Connect the other end of the cable to a USB-enabled power source. The battery symbol on the control panel flashes white while the Hydro Exfoliator is charging. | Application tips: Cleansing head 1: Wide silicone tip for sensitive skin. Cleansing head 2: Silicone cleansing and exfoliation for sensitive skin. Cleansing head 3: Precise silicone for the nose and chin area for sensitive skin. Cleansing head 4: Cleansing and exfoliating. Cleansing head 5: Deep cleansing and pore cleansing. Cleansing head 6: Precise cleansing of the chin and nose area. | Application: Cleanse and moisturize the skin beforehand. Remove the water tank by pulling it out and fill it up to the "Max" fill line with your desired solution. For example, diluted micellar water, diluted salicylic, glycolic or hyaluronic acid. Anything other than water is used at your own discretion. Reinsert the tank on the "Clean Solution" side. Start with the first attachment and work your way up depending on your skin's tolerance. Press the on/off button for a long time to turn the device on and go to the first mode. Press the button again briefly for each subsequent mode change. Before each use, hold the attachment to your hand for 15 to 20 seconds to ensure that the water circulates through the device. Then hold the attachment to the skin and move it directly over the contours of your face in slow, gliding movements. Always keep the device straight. After the treatment, press and hold the on/off button for a long time. Wash your face with cold water and then use a suitable moisturizer. | How to clean the device: Remove and empty the water tank. Fill both sides of the water tank with soapy water and rinse. Wash the attachments with warm soapy water, rinse and allow to dry thoroughly. If the solution line becomes clogged, gently blow through the line to clear the blockage or replace the line. | Depending on your skin type, your skin will be visibly red during or after use. This is normal and should subside within a few hours. If you have severe redness, use a silicone attachment and use the device on a lower setting.

To reduce the risk of burns, electric shock, fire, or injury to persons:
1. Read all instructions before use.
2. If you have any medical concerns, consult your trusted dermatologist before using the Stylpro Hydro Exfoliator.
3. If you notice any abnormalities on your skin during or after use, please consult your specialist. Avoid direct eye contact. Avoid applying directly under the eyes and on the eyelids.
4. To avoid electrical hazards, do not use while bathing or showering.
5. Close supervision is necessary when an appliance is used by or near children or persons reduced or disabled by illness or injury.
6. Do not use on sensitive or broken skin. Do not use on swollen or sunburnt skin or if you have any other skin conditions.
7. Do not operate the appliance if it malfunctions, has been dropped, or damaged in any way. Return the appliance to the nearest service facility for examination, electrical or mechanical adjustment, or repair. No repairs should be attempted by the consumer.
8. Use the appliance only for the purpose described in this manual. The use of attachments not recommended by STYLPRO™ may be hazardous.
9. Do not use outdoors or in locations where aerosol products (sprays) are used or where oxygen is administered.